Arthur P Sell
Group: Registered
Trusted Member Registered
3
Follow
Profile Activity
This is an interesting concept. I have a project that I coul...

In forum Technical - 1912-1928

 2 weeks ago
Hello Ryan, I somehow suspect some of your parts may have...

In forum Technical - 1912-1928

 2 weeks ago
I needed a different engine for my '29 Coupe. I started look...

In forum Technical - Mechanical

 2 weeks ago
I have a few spare axles around. The '29 axles are notorious...

In forum Technical - Mechanical

 2 weeks ago
Unfortunately the pinion gear is missing in both but I think...

In forum Technical 1916-1922 - Model 490

 6 months ago
@david-siedschlag As you probably know the Chevrolet fiber t...

In forum Technical - 1912-1928

 6 months ago
After reading the various posts I would have liked to check ...

In forum Technical - 1912-1928

 6 months ago
For my engines I went a different route. I had a picture of ...

In forum Technical - Mechanical

 6 months ago
Hello Clement, looks like it has had a good restoration. Lik...

In forum General Discussion

 6 months ago
Even on the earlier models equipped with a tube that directe...

In forum What did you do with your vehicle today?

 7 months ago
The early engines had studs with the extra long brass nuts. ...

In forum Technical - Mechanical

 7 months ago
There is a member who occasionally goes to the gathering in ...

In forum Technical - 1933-1936

 8 months ago
Hello Erik, I have my Convertible Landau relocated to Chino ...

In forum Technical - 1929-1932

 8 months ago
There is a cam grinding service in Vancouver Washington who ...

In forum Technical - 1912-1928

 8 months ago
I don't get on here very often, so I didn't know you were lo...

In forum Technical - Trucks

 8 months ago
Page 1 / 4