Notifications
Clear all

powerglide leaks

 

(@william-vance)
Eminent Member Registered
Joined: 10 years ago
Posts: 23
Topic starter  

My car has a '54 cast iron powerglide. I am aware that these old transmissions but I think mine is excessive. I am adding a quart of fluid every 700-800 miles. It seems to be leaking a lot around the shaft where the shifter linkage attaches and around the front of the transmission. I plan on getting the car on jacks and check further when time allows. I plan to pull the engine this winter to do some work and I thought it would be a good time to try to repair some of these leaks.

I know this is difficult question but do you think there are any leaks that can be repaired without a tear down?

Thanks, Pete



   
Quote
Tiny
 Tiny
(@tiny)
Hall Monitor Moderator
Joined: 21 years ago
Posts: 1439
 

I don't know if it's possible to stop a cast iron PG from leaking. I had the PG in my 53 rebuilt and it's still a leaker.


7046 old site posts
Save a life, adopt a senior shelter pet
There are many good people. If you can't find one, be one.
1938 Master Business Coupe-Sold, now living in New Jersey
1953 210 Sedan


   
ReplyQuote
Steve Dalphonse
(@steve-d)
Honorable Member Registered
Joined: 36 years ago
Posts: 483
 

Proper oil level is important. i found this on Chevytalk.
"Engine at operating temperature, idling in Park.
Check level.

If the engine is off- the level will be above the desired mark on the dipstick.

Some of us are running the 'glide one qt below spec to keep the garage floor clean due to some "old age" issues with the main valve body and oil leakage when they SIT.

This post by Gene on the old site : https://vccachat.org/ubbthreads.php/topics/160129/54-powerglide-leak.html


This post was modified 8 hours ago by Steve Dalphonse

7472 old site post


   
ReplyQuote
(@dennis-christianson)
Trusted Member Registered
Joined: 21 years ago
Posts: 79
 

I believe the 54 pg you check the level running warmed up in neutral and not park. I could check the dipstick on my 54 but I think that’s what it says. If you take the engine out I would at least replace the oring in the torque converter. I’m not a big fan of additives but in the past I have used the stop leak the will help soften the seals with good results.



   
ReplyQuote
(@william-vance)
Eminent Member Registered
Joined: 10 years ago
Posts: 23
Topic starter  

Thanks for the replies. I will keep researching until pull the engine.



   
ReplyQuote
Steve Dalphonse
(@steve-d)
Honorable Member Registered
Joined: 36 years ago
Posts: 483
 

@dennis-christianson You are correct. My shop manual does state to check the oil level with the car warmed up and in NEUTRAL. I have deleted part of my post above.


7472 old site post


   
ReplyQuote
Share: