Steve Dalphonse
Steve Dalphonse
Group: Registered
Estimable Member Registered
4
Follow
Profile Activity
@ralph-c-vemmer There is no gauge to measure the rods that I...

In forum Technical - 1929-1932

 3 months ago
Don;t forget to specify the model of your car and which door...

In forum Technical - 1929-1932

 3 months ago
@chip Thanks Chip. I don't have a lift and I agree it would ...

In forum Technical - 1929-1932

 3 months ago
I have not done the Larry Jackson conversion however I did w...

In forum Technical - 1929-1932

 3 months ago
@35mike Yes it is the slip-on muffler. The stud is at the en...

In forum Technical - 1929-1932

 3 months ago
Attended car club celebration

In forum What did you do with your vehicle today?

 3 months ago
@jon-tagge The upper part of the A pillar on the Belair hard...

In forum Technical - 1949-1954

 3 months ago
You will need to source correct rivets or perhaps use rivet ...

In forum Technical - 1929-1932

 3 months ago
@harry-truppner Yes the stud anchors the muffler and forces ...

In forum Technical - 1929-1932

 3 months ago
@35mike Well it appears you will need a "TINY" bit of assist...

In forum Forum and Website Usage Questions

 3 months ago
Loose muffler

In forum Technical - 1929-1932

 3 months ago
@esf You're welcome. I think most of the interior plated met...

In forum Technical - 1929-1932

 3 months ago
When you are logged in and the classified tab is highlighted...

In forum Forum and Website Usage Questions

 3 months ago
Outside metal plating on the 32 was chrome.

In forum Technical - 1929-1932

 3 months ago
@dunfire + Your contributions are certainly appreciated . It...

In forum General Discussion

 3 months ago
Page 5 / 11