Chip
Chip
Group: Moderator
Title: Member Moderator
4
Follow
I believe that the two (Powerglide and Manual) master cylind...

In forum Technical - 1949-1954

18 hours ago
I think the problem is that Jeffrey-Salz is not registered a...

In forum General Discussion

18 hours ago
Bill D the '51-'52 Technical Advisor is probably who I would...

In forum Technical - Body and Interior

5 days ago
Any rear main bearing gap over 0.002" is likely to drip or s...

In forum Technical - 1937-1945

1 week ago
Glad it worked out for you. I have some of the spare parts b...

In forum Technical - Electrical - 6 Volt

1 week ago
I only found a single part number in the "Parts List Four Ni...

In forum Technical - 1912-1928

1 week ago
There are no accurate measurements for your '28 Convertible ...

In forum Technical - Body and Interior

1 week ago
A swing arm similar to the drawing is what is needed. Ford p...

In forum Technical - 1929-1932

2 weeks ago
I am not sure what advise you are needing. If you have the s...

In forum Technical - Electrical - 6 Volt

2 weeks ago
The hottest water from the cylinder head should circulate to...

In forum Technical - Trucks

2 weeks ago
Glad I could help recover the memory.

In forum Technical - 1929-1932

3 weeks ago
The 1929 carburetor did have an air cleaner with copper ribb...

In forum Technical - General

3 weeks ago
That part attaches to the brake cross rod to operate the bra...

In forum Technical - 1929-1932

3 weeks ago
The "Throttle" button is only used to increase the idle spee...

In forum Technical - 1929-1932

4 weeks ago
If the story happens today then bolt cutters might be an opt...

In forum Technical - General

4 weeks ago
Page 1 / 13