Chip
Chip
Group: Moderator
Title: Member Moderator
4
Follow
Bruce, congratulations on the acquisition. Preservation is t...

In forum Technical - 1929-1932

8 months ago
My guess is a wire with deteriorated insulation that is not ...

In forum Technical - General

8 months ago
The clearance for rods is ~0.001". As Tiny wrote the method ...

In forum Technical - 1912-1928

8 months ago
Congratulations on the test run. Any generator output over 1...

In forum Technical - 1929-1932

8 months ago
The only sealer needed on the front main cap would be where ...

In forum Technical - 1929-1932

8 months ago
The part with the channel looks like the top header that goe...

In forum Technical - 1929-1932

8 months ago
The early '31 models did have trunk lid that overlapped the ...

In forum Technical - Body and Interior

8 months ago
Reassembling the U-joint can be a challenge. There is a spec...

In forum Technical - 1929-1932

8 months ago
The gears should not be loose or wiggly on the shafts or the...

In forum Technical - Mechanical

8 months ago
I suspect the bushings on the gears or shaft wear is the pro...

In forum Technical - Mechanical

8 months ago
The block obviously was a later casting of a 1940 engine blo...

In forum Technical - Trucks

8 months ago
The size of the distributor caps was changed in 1933 Master ...

In forum Technical - Electrical - 6 Volt

8 months ago
We need to remember to ask the question Is the starter speed...

In forum Technical - Electrical - 6 Volt

8 months ago
Excellent plan. It is an historical object that too much "re...

In forum What did you do with your vehicle today?

8 months ago
The sending unit with two corks is the '30 to early '31 one....

In forum Technical - 1929-1932

8 months ago
Page 9 / 13