Chip
Chip
Group: Moderator
Title: Member Moderator
4
Follow
Profile Activity
The clearance should be 0.001-0.002". The process described ...

In forum Technical - Mechanical

 4 months ago
I have used fractional horsepower belts mostly 5L type for y...

In forum Technical - 1912-1928

 4 months ago
If your '31 Coupe is early production some didn't have metal...

In forum Technical - 1929-1932

 4 months ago
Glad you finally got to talk to Bill D. He has forgotten mor...

In forum Technical - 1949-1954

 4 months ago
This past Monday was the time I was on Bills cell phone. It ...

In forum Technical - 1949-1954

 4 months ago
There should be a slot in the horizontal part of the clamp w...

In forum Technical - 1929-1932

 4 months ago
That one was held despite all the hype of impending Covid di...

In forum General Discussion

 4 months ago
Gray epoxy type suggests J B Weld to me.

In forum Technical - Mechanical

 4 months ago
@tiny I told the T/A Bill D. that a poster on the Forum was ...

In forum Technical - 1949-1954

 4 months ago
His email address and phone number is listed in the G&D ...

In forum Technical - 1949-1954

 4 months ago
Just talked to 51-52 Technical Advisor Bill Dirnberger on hi...

In forum Technical - 1949-1954

 4 months ago
I started to write a step by step process but it got too tim...

In forum Technical - Body and Interior

 4 months ago
Hey good photo Mike. Captured my '28 Coupe as well as a few ...

In forum General Discussion

 4 months ago
Check the impeller on the water pump for indication that it ...

In forum Technical - 1946-1948

 4 months ago
Welcome to the VCCA family from a long time member. You have...

In forum General Discussion

 4 months ago
Page 5 / 11