Loc: Rochester, MA 02770
Does anyone have a good photo of the MC showing how the pedal arm is connected to the swing pin? I replaced my MC last year and I transferred the arm and pin over, but the arm broke off due to a weld that did not penetrate. Before I fully weld the arm to a new pin I wanted to see if anyone has any feedback on this or has seen it happen. From what I can see the bolt in the center holds the pin in place by a groove machined in the center area of the pin. Fortunately I was only moving the car in my driveway when this happened, but I obviously lost my brakes completely. Thank you in advance for your response(s)!