Until today I assumed determining where the splash pans go would be easy. But when I got them out of the box and tried to find how they fit only two of the four pan locations are apparent.

The two pans that fit under the front fenders just below the hood I figured out. The other two I have turned in about a hundred different positions on both sides and cannot see where they go and where they are bolted on.

Also, I am wondering if installing them will involve dis-assembly of the fenders, radiator support, etc.

Any pictures or other help would be greatly appreciated. I assume the 33 - 35 Standards would all be about the same.

There are fender aprons that go from the bottom edge of the fender below the hood edge to the frame.

There are also engine pans,

Either of those what you're referring to?

33 is a little different but it's probably like 34m

Joe

Joe,

I am fairly certain they are the engine pans as you describe. There are also two small brackets that I assume are used with them. If you could describe how they attach or post or email me a picture I would be very appreciative! My email address is:

youngfalconearthlink

Thanks for the reply!

I'll try to get some picture of my 33 std & the 34 master. I'm not sure how close it will be but it might give you some ideas. I'll e-mail you later unless someone else has pictures before...Joe

I sent you a picture of the passenger side of my '34 Master.

Pat,

Thanks for the pictures again. I was also fortunate to get a good look at a '35 Standard at the Barrett-Jackson Auction where I currently am. I almost had it figured out but now know exactly how they fit!