1956 235 truck - VCCA Chat

You are not logged in. [Log In] VCCA Homepage » Forums » Chevrolet 1955-1960 » 1955-57 » 1956 235 truck

Today's Birthdays

None of any significance today.

Featured Chat Guy (or Gal)

Andys29

Registered: 11/08/08
Posts: 1014

VCCA Member's Photos

Member's Projects

Top Posters

Topic Options

Rate This Topic

#177097 - 07/03/10 12:18 AM 1956 235 truck
bja Grease Monkey Registered: 07/03/10 Posts: 4 Loc: colorado	1956 235 truck block #3764476 head # 3836848 in a 42 3/4t panel just had it rebuilt and put in hydraulic lifters at low idle oil shoots about 1 inch plus out the rocker holes i can't adjust lifters while running oil goes everywhere oil gage reads about 40 pounds is this right? can i adjust lifters cold?
Top

#177152 - 07/03/10 11:13 PM Re: 1956 235 truck [Re: bja]
bobg1951chevy Registered: 02/17/08 Posts: 801 Loc: Ellijay, GA	Were the lifter bores factory drilled with oil passages for the hydraulic lifters that you installed ????????? _________________________ When I'm behind the wheel of my 1951 Chevy ... it's 1957 in high school again! www.picturetrail.com/sfx/album/view/21579056
Top

#177170 - 07/04/10 07:51 AM Re: 1956 235 truck [Re: bobg1951chevy]
bja Grease Monkey Registered: 07/03/10 Posts: 4 Loc: colorado	don't know i could pull a lifter what do i look for? the lifters are loud?
Top

#177181 - 07/04/10 10:23 AM Re: 1956 235 truck [Re: bja]
bja Grease Monkey Registered: 07/03/10 Posts: 4 Loc: colorado	been doing a little looking on the web looks like this block was made for solids when it was rebilt a hydraulic cam was used so it looks like the cam and lifters have to be changed what do you think?
Top

#177189 - 07/04/10 01:08 PM Re: 1956 235 truck [Re: bja]
AntiqueMechanic Registered: 12/02/01 Posts: 7531 Loc: Vancouver, WA	A perfect example of "Original is the only way to go". _________________________ RAY Member Chat Group - Non-Geographical Region Chevradioman http://www.vccacolumbiariverregion.org/
Top

#177218 - 07/04/10 08:12 PM Re: 1956 235 truck [Re: bja]
bobg1951chevy Registered: 02/17/08 Posts: 801 Loc: Ellijay, GA	Use the solid lifter cam and solid lifters is my thought. If the block does not have the oil passage I spoke of above, it won't work correctly. _________________________ When I'm behind the wheel of my 1951 Chevy ... it's 1957 in high school again! www.picturetrail.com/sfx/album/view/21579056
Top

#177221 - 07/04/10 08:27 PM Re: 1956 235 truck [Re: bja]
bja Grease Monkey Registered: 07/03/10 Posts: 4 Loc: colorado	bob thanks for your post i'll pull the engine tomorrow and start over again
Top