tranny problem after installing new clutch

You are not logged in. [Log In] VCCA Homepage » Forums » Welcome » New To Chat? - Questions? » tranny problem after installing new clutch

Today's Birthdays

Featured Chat Guy (or Gal)

29guy

Registered: 10/27/10
Posts: 20

VCCA Member's Photos

Member's Projects

Top Posters (over the past 30 Days)

Topic Options

Rate This Topic

#160962 - 01/03/10 07:11 PM tranny problem after installing new clutch
jaran Grease Monkey Registered: 01/03/10 Posts: 1 Loc: C alifornia	after installing a new clutch on m 1954 chevy truck the clutch dose nt totally disengage and will not go into gear had the flywheel resurfaced
Top

#160967 - 01/03/10 08:13 PM Re: tranny problem after installing new clutch [Re: jaran]
Mike McCagh Registered: 11/10/03 Posts: 1853 Loc: cumberland, md	appears to be clutch linkage mal-adjustment or incorrect throw out bearing/throw out fork. can you back off the linkage enough to feel slop in the fork/bearing assembly?good luck.mike
Top

#160983 - 01/04/10 06:06 AM Re: tranny problem after installing new clutch [Re: Mike McCagh]
Chip Registered: 02/27/06 Posts: 1160 Loc: Asheville, NC	Other things to check: -- Pedal linkage not properly adjusted ==> not fully lifting pressure plate when pedal is to floor. -- Pilot bearing damaged during reinstallation or tranny input shaft not properly mated to pilot bearing. -- Clutch plate facing wrong way. -- Clutch plate not free to slide on input shaft splines. Hope that helps. Good luck with solving it. All the Best, Chip _________________________ "It's wise to choose a SIX"
Top

#160985 - 01/04/10 07:38 AM Re: tranny problem after installing new clutch [Re: Chip]
MrMack Registered: 12/14/01 Posts: 11879 Loc: Central Texas	It may be that the clutch lever is not fastened to the ball. _________________________ Lone Star Region Chat Group Chapter member http://www.lsrclub.org Life's a long winding trail, ride a good horse!
Top